Servo Motor Explained: How a Robot Arm Stops at an Angle
A servo is a motor with a position sensor and a control loop. You ask for an angle and it keeps correcting until it gets there.
The controller keeps measuring the angle and pulls the arm back to the green target.
A plain motor just spins when powered. A servo adds a sensor that reports its angle and a small controller that compares the angle with the target.
If the shaft is short of the target the controller drives it forward. If it overshoots, it pulls back. This repeats very quickly until the error is nearly zero.
You can say "go to 90 degrees" and the joint goes there and holds, even if something pushes on it.
A plain motor has no idea where it is. You could only guess angles by timing, and any push or heavy load would ruin it.
Too strong a correction makes it shake or overshoot. Tuning the controller matters.
What does a servo have that a plain motor lacks?
Go deeper in the Atlas
Motors and Mechanics
- Gears Explained
- Servo Motor Explained
- How a Robot Arm Picks Up a Cup (6 Motors, Explained Simply)
- Why Are Robots So Good at Repeating?
- Harmonic Drive
- Micro Robots
- Stewart Platform
- Snake Robots
- Inverse Kinematics
- Degrees of Freedom
- Torque vs Speed
- PWM Explained
- Stepper Motor Explained
- Why Robot Motors Get Hot Even When Holding Still
- Delta Robot Explained
- SCARA Robot Arm