Gain and Damping: Why a Robot Arm Shakes
Correct too hard and the arm shakes. Correct too gently and it is slow. Gain sets the push, damping calms the overshoot.
The controller keeps measuring the angle and pulls the arm back to the green target.
Gain is how strongly the controller pushes when there is an error. Higher gain reacts faster, but a robot can overshoot the target, swing back, overshoot again and shake.
Damping works like friction against the motion. It removes the extra swing so the arm settles on the target instead of ringing around it. Tuning is finding the mix that is quick and still calm.
A well-tuned arm moves fast, stops where you want it and stays still once it arrives.
Too much gain and too little damping gives a shaking arm. Too little gain gives a sluggish arm that never quite gets there.
The best values change with load, speed and wear, so a setting that works empty may shake with a heavy payload.
What does damping do in a robot arm controller?
Go deeper in the Atlas
Control and Balance
- Feedback Control Explained
- Line Follower Robot
- Why You Don't Fall in a Moving Bus (And Robots Do)
- How Boston Dynamics Robots Keep Their Balance
- How Drones Stay Level in Strong Wind
- PID Controller in 60 Seconds
- ROS 2
- How Robots Learn to Walk
- A* Pathfinding
- State Machine
- Robot Latency
- Reward Hacking
- Sim to Real
- How Humanoid Robots Walk Without Falling (ZMP Explained)
- Gain and Damping
- How Self-Driving Cars Think
- Swarm Robotics
- Robot Dog (Quadruped) Explained
- How a Drone Hovers
- Behavior Tree