How Humanoid Robots Walk Without Falling (ZMP Explained)
A walking robot is always almost falling. The zero moment point is the idea that tells it where it can safely put its weight.
The IMU reports tilt and spin rate, and the controller pushes back instantly.
When a foot is on the ground the floor pushes back at one effective spot. The zero moment point, or ZMP, is that spot. If it stays inside the area under the foot, the robot does not tip over.
Walking planners choose foot steps and body motion so the ZMP stays inside the support area at every moment, then the joints are commanded to follow that plan.
A humanoid can plan steps that keep it balanced, even though it spends most of its time on one foot.
Without a rule for balance, the robot would just lean and topple, or need a wide static stance and could never take a real step.
ZMP works best on flat, firm ground. Rough terrain and pushes need extra methods and fast feedback from sensors.
What must the ZMP stay inside to keep a walking robot from tipping?
Go deeper in the Atlas
Control and Balance
- Feedback Control Explained
- Line Follower Robot
- Why You Don't Fall in a Moving Bus (And Robots Do)
- How Boston Dynamics Robots Keep Their Balance
- How Drones Stay Level in Strong Wind
- PID Controller in 60 Seconds
- ROS 2
- How Robots Learn to Walk
- A* Pathfinding
- State Machine
- Robot Latency
- Reward Hacking
- Sim to Real
- How Humanoid Robots Walk Without Falling (ZMP Explained)
- Gain and Damping
- How Self-Driving Cars Think
- Swarm Robotics
- Robot Dog (Quadruped) Explained
- How a Drone Hovers
- Behavior Tree