FANUC M-2000iA
A robot picks up a whole car by the side, swings it through the air, and sets it down to within a third of a millimeter.
In one sentence
The FANUC M-2000iA/2300 is a six-axis industrial robot that lifts 2,300 kg, enough to carry a finished car body or a truck chassis around a factory.
The wow factor
Three things that make FANUC M-2000iA genuinely impressive.
Its 2,300 kg payload lets it lift and hold an entire car from the side.
It weighs 11,000 kg, about the mass of two adult elephants, and reaches 3.73 m.
FANUC calls its wrist the strongest in the world.
How it works
A step-by-step breakdown, in plain English.
- 1A FANUC R-30iB Plus controller plans a path for six servo-driven axes.
- 2Massive gear reducers at each joint multiply motor torque; the wrist alone handles moments of 29,400 N·m on two axes.
- 3Counterbalancing and a rigid cast structure keep the arm accurate under a payload heavier than a car.
- 4Joint speeds are slow by robot standards, 14 to 40 degrees per second, because the loads are enormous.
- 5Encoders on every axis feed back position so the robot repeats a placement within ±0.3 mm.
Where you've probably seen it
The M-2000iA is the robot in viral clips of a yellow arm lifting whole cars at trade shows, and the usual answer to "what is the strongest robot arm?"
The team behind it
FANUC Corporation of Oshino, Yamanashi, Japan, the world's largest maker of industrial robots and CNC controls, known for painting every robot FANUC yellow.
The full story
The FANUC M-2000iA/2300 is the heaviest-lifting model in FANUC's M-2000 series, a line introduced at IMTS 2008 with 900 kg and 1,200 kg models that FANUC billed as the world's largest and strongest six-axis robot. It is a six-axis, floor-mounted articulated arm with a maximum payload of 2,300 kg and a horizontal reach of 3,734 mm, and the robot itself weighs 11,000 kg. FANUC says it will easily lift and position an entire car, or load bulky castings onto machine fixtures, and the company describes its wrist as the strongest in the world, with moments of 29,400 N·m on the J4 and J5 axes and 8,820 N·m on J6. Repeatability is ±0.3 mm per the datasheet. Because of the loads, axis speeds are modest, from 14 to 40 degrees per second. The wrist and J3 arm are sealed to IP67 and the body to IP54 or optionally IP56. It runs on FANUC's R-30iB Plus controller. Typical jobs are moving car bodies between assembly stations, handling truck frames and loading heavy castings.
What do you think?
Cast your one-and-only vote. Be the first to vote.
Learn the science behind FANUC M-2000iA
Three Atlas entries that explain how FANUC M-2000iA actually works.
Mind-blowing facts
The wrist can resist a bending moment of 29,400 N·m on two of its axes.
Its fastest axis turns at only 40 degrees per second; its slowest at 14.
Every FANUC robot is painted the same yellow, a company tradition.
Plain English. Free. Unsubscribe in one click.
Sources
Every number on this page comes from one of these. If a spec is missing, no source stated it.
- FANUC America — M-2000iA/2300 product pagewww.fanucamerica.com
- FANUC M-2000iA/2300 datasheet (PDF, via Robots.com)assets.robots.com
- New Atlas — FANUC debuts world's largest, strongest six-axis robot at IMTS 2008 (Sep 2008)newatlas.com
Facts checked